We are more than an aluminium alloy solution provider.
Do you need consumer aluminium alloy products or learn more info about aluminum alloy prices?
As noted earlier, temper designations are alphanumeric designations appended to the alloy designations that convey to the producer and user alike information about the general manner in which the alloy has been mechanically and/or thermally treated to achieve the
The aluminum alloy data sheets in Mat will generally have a temper designation connected with them to indicate the treatment used to produce the properties listed. Basic
Aluminium Alloys are supplied in a very wide range of tempers with two principal groups: Non-heat treatable alloys - Alloys whose strength/mechanical properties
View a complete list of aluminum alloy tempers and their subdivisions. Find the right solution for your manufacturing or industrial
Four basic temper designations are used for aluminum alloys. They are - as fabricated; -0: annealed; -H: strain hardened and - thermally treated. A fifth designation, -W, is used
Basic Aluminum Heat Treatment Designations. F As Fabricated - No special control has been performed to the heat treatment or strain hardening after the shaping process such as casting, hot working, or cold working. O Annealed - This is the lowest strength, highest ductility temper. H Strain Hardened - (applied to wrought products only) Used for
Txx51 Stress relieved by stretching. Applies to the following products when stretched the indicated amounts after solution heat-treatment or cooling from an elevated temperature shaping process. Plate: 1-1/2 to 3% permanent Rod, bar, shapes, extruded tube: 1 to 3% permanent Drawn tube: 1/2 to 3% permanent
The T3 and T4 tempers are based on natural ageing for 4 days. For 2XXX alloys, improvements in properties after 4–5 days are relatively minor, and become stable after one week. The Al–Zn–Mg–Cu and Al–Mg–Cu alloys (7XXX and 6XXX), harden by the same mechanism of GP zone
Temper 7050-T7451 Specification AMS 4050D MIL-HDBK-5 Approved Coverage OTHER PRODUCT FORMS Forgings, extrusions, and fasteners in Alloy 7050 are also available. REFERENCES: 1. Alcoa Green Letter . The Aluminum Association,
Parameters of coated aluminum Equivalent product name Color coating aluminium, pre painted ( prepainted ) Temper O - H112, T3 - T8, T351 - T851 etc Width 20mm1590mm Thickness 0.06mm1.0mm Inside Diameter 405mm, 505mm, 150mm, 75mm
Corrosion Of Bare And Coated Al 5052-H3 And Al 6061-T6 In. that wrought Al 5052 had good corrosion resistance in seawater. This wrought aluminum alloy of the 5000 series is a strain-hardenable alloy. The composition of Al 5052 is magnesium, chromium, and a balance of aluminum The H3 temper was selected and is generally used